Awlgrip G8010Q; Off-White (Lf)-Quart

Description

Maintenance It is difficult for dirt grime and grease to adhere to an Awlgrip, Awlcraft 2000 or Awlgrip HS Topcoat. G3010, 4 oz. For example, if a 25% reduction is used, overall mix is 1:1:½ by volume (8 oz. Surface Preparation For best results AWLGRIP colors should be applied over properly prepared 545 Epoxy Primer, 345 HS Primer or in brush/roller applications Awlquik Primer. Brush/Roller applications require at least two coats. Typically three coats are recommended for spray applications. Brush/Roller application: Apply Awlgrip Topcoat in at least two coats, allowing 16 hours between each coat. Overall mix is 2:1:⅓-1 by volume (8 oz. Sanding between coats with 320-400 grit paper will provide a smoother finish. Spray application: Apply a light, smooth, slightly wet tack coat to the surface. Reduce 10-33% with T0031. Then apply the second coat as an almost full wet coat. Coats two and three are not "full, wet" coats. Allow the second coat to "flash off" 30-45 minutes until only slightly tacky before applying a third coat. Awlgrip colors may also be applied over recently applied Awlgrip topcoats/showcoats – consult your local Technical Sales Representative for advice. Brush/Roller: Mix by volume two parts Awlgrip Topcoat Base Component with one part Awlcat #3/H3002 Brushing Converter until one smooth, homogenous mixture is obtained. Reducer addition level required to achieve 14 seconds viscosity (DIN4 or equivalent) varies color to color. However, over time, a build up of.

Key Features

• Allow tack coat to "flash off" 15 to 45 minutes.
• Sanding between coats with 320-400 grit paper will provide a smoother finish.
• Overall mix is 2:1:⅓-1 by volume (8 oz.
• Allow the second coat to "flash off" 30-45 minutes until only slightly tacky before applying a third coat.
• Do not apply G3005 directly to bare wood.
• For example, if a 25% reduction is used, overall mix is 1:1:½ by volume (8 oz.